PDA

View Full Version : Equium M50 will not recognise the LAN port - error: Network Cable unplugged



jopen50
27.07.2006, 09:36
I own a Toshiba Equium M50 and have problems with the Marvell Yukon 88E8036 PCI-E Fast Ethernet Controller.

I used to connect via an 'ADDON' Modem/ADSL Switch and had no problems. I then replaced the ADDON with a 'NETGEAR' DG834G ADSL Modem/Router to gain the wireless port, and since then my machine will not recognise the LAN port. <error: Network Cable unplugged>.

I know that the cables are OK as I used them with other laptops and had no trouble. I can also plug in a PCI card to connect without any problems. It looks to me as if the Marvell Yukon 88E8036 PCI-E Fast Ethernet Controller has a problem with the netgear Modem/Router.

Anyone out there with a similar experience and some advice/suggestions?

PLEASE

Jimi
28.07.2006, 16:52
Hi

For me it doesn’t show like a LAN card problem but your router is a problem.
Check the device manager if the LAN card was properly recognized. If there are no yellow exclamation marks so everything is ok!
You can try to delete the LAN card from the device manager and after new reboot install the LAN driver again.

The issue has stared after installing or connecting the new Netgear modem router.
Therefore I would recommend to checking firstly the settings or to update the firmware on this router.

I have found additionally these useful websites
http://compnetworking.about.com/od/windowsnetworking/f/cableunplugged.htm

http://www.experts-exchange.com/Networking/Broadband/DSL_Cable/Q_20381405.html